Menu

Recent Works by Jamie Lang

Posted by

Hutchinson Center for the Arts

jamie-lang

The exhibit runs thru December 31, 2016

Hutchinson Center for the Arts, 15 Franklin St SW, Hutchinson, MN. M-TH 10 am –  5 pm, F 12-4 pm.

For more information: 320-587-7278, info@hutchinsonarts.org, www.hutchinsonarts.org/. Facebook Page: www.facebook.com/HutchinsonCenterForTheArts/

Click for Facebook Event Page.


Lang’s work reflects his thoughts about architecture, decoration, and memory. His mixed media sculptures are minimal geometric structures that reveal their own architectural planning. Each of the structures contain multiple layers. Jamie adds layers of plaster, pigment and wax to emphasize and decorate the rough surfaces of the form. By altering the surfaces, each layer asserts the passage of time and the burying and recovery of memories.

These pieces are created by casting adobe into wooden forms or plaster molds. Adobe is a natural building material made from sand, clay, water, and some kind of fibrous or organic material (sticks, straw, etc.), which the builders shape into bricks using frames and dry in the sun. Adobe buildings are similar to cob and mudbrick buildings. Adobe structures are extremely durable, and account for some of the oldest existing buildings in the world. The surface of the tiles are created from encaustic painting. Encaustic is a wax based paint (composed of beeswax, resin and pigment), that is kept molten on a heated palette and then fused, (or re-melted). The word encaustic comes from Greek and means ‘to burn in’, which refers to the process of fusing the paint. Due to the fact that beeswax is impervious to moisture, it will not deteriorate, it will not yellow and does not require the use of any chemical solvents. The surface can be polished to a high gloss, it can be modeled, sculpted, textured, and combined with collage materials. It cools immediately, so that there is no drying time, yet it can always be reworked. Since encaustic painting is made with wax, extreme hot conditions could change the art. Indoor environments, even very warm ones, are not usually hot enough to melt wax—although it is not advised to place the painting in direct sunlight. Cars are the greatest hazard because the heat of the sun is intensified through car windows. It takes at least 160 degrees to bring wax to a molten state. Like any piece of artwork, if handled with care, it will last a lifetime

Written by

SMAC

No Comments Yet.

Leave Your Comment

X
Skip to content